Note:  it is critical to follow the steps in this document, otherwise will the printer almost flood the page when printing. 


This document goes over how get the Calibrations (SetGold Calibrations) to function properly in the Navigator HP DFE versions 721A and 222B,

 

  1. Close Navigator Server completely
  2. Open the file RenderConfigs.json in Notepad++
     (C:\Navigator\Navigator\Config\RenderConfig) 
  3. Browse to the line CalName: in each renderconfig listing
  4. Remove the name of the Calibration, but leave quotation marks (“”)
    Example: Should initially read CalName: “Plain Paper 300”
     Should look like this when finished CalName: “”
  5. Save and close the RendConfig.json
  6. Browse to the Calibrations.json and move it to the desktop
     (C:\Navigator\Navigator\Config\RenderConfig\Calibration)
  7. Start Navigator Server
  8. Open the Navigator Configuration Editor in a Web Browser
  9. Go to the Calibrations window and select the Plain Paper 300 calibration from the Paper Profile menu
  10. Click “Print New Target”. You do not need to actually print it on the HP, but you can if you like
  11. Now Select Plain Paper 600 from the Paper Profile menu
  12. Click “Print New Target”
  13. Go to the Render Configs tab
  14. Select the Plain Paper 300 Render Config
  15. From the Calibration menu select Plain Paper 300
  16. Click the checkmark to save the setting change
  17. Select the Plain Paper 600 Render Config
  18. From the Calibration menu select Plain Paper 600
  19. Click the checkmark to save the setting change
  20. You should now be able to print using the correct profiles and calibrations

 

If you have any questions about these directions, please reach out to Xitron Support via email at xitronhelp@xitron.com