The purpose of this article is define the setting of the 10G Intel Ethernet Converged Network Adapter X540-T2 for use with Xitron products. If you are using a different Network Adapter then these setting may not apply.
If you are using a high speed inkjet system that requires a consistent data rate, this article may be for you. Examples of such systems: Meteor, Memjet.
Intel Driver Version 4.1.228.0
Flow Control: Rx & Tx Enabled
Interrupt Moderation: Enabled
Interrupt Moderation Rate: Adaptive
IPsec Offload: Auth Header & ESP Enable
IPv4 Checksum Offload: Rx & Tx Enabled
Jumbo Packet: 9014 Bytes
Large Send Offset V2 (IPv4): Enabled
Large Send Offset V2 (IPv6): Enabled
Locally Administered Address: (leave blank)
Log Link State Event: Enabled
Low Latency Interrupts Ports: (do not define / unchecked)
Low Latency Interrupts: Disabled
Maximum Number of RSS Queues: 8 Queues
Packet Priority & VLAN: Packet Priority & VLAN Enabled
Receive Buffers: 1024
Receive Side Scaling: Enabled
Speed & Duplex: Auto Negotiate
TCP Checksum Offload (IPv4): Rx & Tx Enabled
TCP Checksum Offload (IPv6): Rx & Tx Enabled
Transmit Buffers: 1024
UDP Checksum Offload: (IPv4): Rx & Tx Enabled
UDP Checksum Offload: (IPv6): Rx & Tx Enabled
Configure both adapters!
